New MIG/MAG welder from GYS
Designed for maintenance and general fabrication welding using mild steel, stainless steel and aluminium, the TRIMIG 255-4S is suitable for heavy-duty welding of mild steel and stainless steel using 1mm diameter wire.
The three-phase, 7.5kVA, 400V 50/60Hz machine is rated 220A at 35% duty cycle at 40°C and 150A at 60% duty cycle at 40°C.
Features include three welding functions – normal welding, spot welding with adjustable spot diameter and delay spot welding with spot welding time adjustment between two spots. The ‘synergic welding’ mode provides the user with fast and easy setting. By turning the control on the front panel to ‘optimal synergic’ then inputting the wire type, the wire diameter and the power and the equipment will automatically set the optimum wire speed setting ready to weld. In the ‘synergic welding’ mode the machine is factory set for Ar/CO2 for mild steel welding, to change to CO2 use the control panel.
Using the normal manual welding mode, the wire feed speed can be adjusted between 1-15m per minute and the voltage can be set using the 10-step switch.
The equipment comes supplied with a 4m long 250A long torch and earth clamp, whilst an accessory pack containing contact tips, contact tip supports, nozzles and springs is available as an option.
GYS Ltd, Unit 2 Spartan Close, Tachbrook Park, Warwick CV34 6RS; tel: (01926) 338609.
The three-phase, 7.5kVA, 400V 50/60Hz machine is rated 220A at 35% duty cycle at 40°C and 150A at 60% duty cycle at 40°C.
Features include three welding functions – normal welding, spot welding with adjustable spot diameter and delay spot welding with spot welding time adjustment between two spots. The ‘synergic welding’ mode provides the user with fast and easy setting. By turning the control on the front panel to ‘optimal synergic’ then inputting the wire type, the wire diameter and the power and the equipment will automatically set the optimum wire speed setting ready to weld. In the ‘synergic welding’ mode the machine is factory set for Ar/CO2 for mild steel welding, to change to CO2 use the control panel.
Using the normal manual welding mode, the wire feed speed can be adjusted between 1-15m per minute and the voltage can be set using the 10-step switch.
The equipment comes supplied with a 4m long 250A long torch and earth clamp, whilst an accessory pack containing contact tips, contact tip supports, nozzles and springs is available as an option.
GYS Ltd, Unit 2 Spartan Close, Tachbrook Park, Warwick CV34 6RS; tel: (01926) 338609.
